Re: [Paparazzi-devel] [TWOG] CAM Port Pins

[Kristofer Von Ahnen]

Is there a way to signal it On/Off? I guess voltage regulation is the 
wrong phrase.

~Kris

On 12/02/2014 02:46 AM, Rolf Noellenburg wrote:
> Hello Kris,
>
> following the schematics given on the side of your link, CamSW is on a 
> pin similar to a led switch and is not suitable to control a servo. 
> Only the outputs SRV0 to SRV7 can drive a servo directly on a TwoG.
>
> By the way: the servo pins don't adjust a voltage in order to modify 
> the position of the servo but provide a PWM signal which is translated 
> to a corresponding angle by the servo.
>
> Best regards,
> Rolf
>
>
> Am 02.12.2014 01:03, schrieb Kristofer Von Ahnen:
> > Is it possible to regulate the voltage of the CamSW pin on the TWOG 
> > board (http://wiki.paparazziuav.org/wiki/TWOG/v1.0) for sending a 
> > hardware signal to a separate device? I notice in the cam_control 
> > module that the servo pins are being used to adjust a camera's 
> > position by sending commands, but can the same be done with the CamSW 
> > pin?
> >
> > Best,
> > ~Kris
> >
> > _______________________________________________
> > Paparazzi-devel mailing list
> > address@hidden
> > https://lists.nongnu.org/mailman/listinfo/paparazzi-devel
>
>
> _______________________________________________
> Paparazzi-devel mailing list
> address@hidden
> https://lists.nongnu.org/mailman/listinfo/paparazzi-devel