Re: [Paparazzi-devel] Airspeed sensor error

[Felix Ruess]

Hi Kiran,

if you have the airspeed_ets module loaded and AIRSPEED_ETS_SYNC_SEND defined it should send a message with every measurement. See https://github.com/paparazzi/paparazzi/blob/master/sw/airborne/modules/sensors/airspeed_ets.c#L190

If you are still using v5.0, the define is still called SENSOR_SYNC_SEND

Can you please post your full airframe config and the exact paparazzi_version if you are still having troubles?

Cheers, Felix

On Thu, Jul 17, 2014 at 4:35 PM, address@hidden <address@hidden> wrote:

Hi felix,

Thank you for your repsonse.

I tested the airframe file you sent me using the regular "Clean & Build" procedure but it keeps giving me an error expecting an end of tag for target. I also edited it until I was able to receive a "Done"(generated code) from the system, following which I tested it,but again, I was only able to receive an "Airspeed" indication in my messages and not an Airspeed_ETS.

Since I am new to this system, i'm having a lot of trouble solving it. I would really appreciate it if you provide some guidance for the same.

Thanking you.

Kiran,

Sent from Yahoo Mail on Android

_______________________________________________
Paparazzi-devel mailing list
address@hidden
https://lists.nongnu.org/mailman/listinfo/paparazzi-devel