Re: [Paparazzi-devel] Support for MediaTek MT3329

[Jake Tarren]

Sure!  The GPS is http://store.diydrones.com/MediaTek_MT3329_GPS_10Hz_p/mt3329-01.htm

And it's on this breakout board:  http://store.diydrones.com/MediaTek_MT3329_Adapter_Basic_p/br-0014-02.htm

I think it is as simple as hooking the 5v in, ground, tx, and rx up.  but there's no info on how to configure it.  I don't suppose if I plug it in it'll just work with the default configuration, and I can't find anything on what firmware to put on it.

On Tue, Apr 2, 2013 at 11:26 PM, Stephen Dwyer <address@hidden> wrote:

Hi Jake,

You might have to be more specific about which GPS exactly you are using (product page? datasheet?), but I think you should just be able to hook up TX out from the GPS to RX in on UART3, and RX in to the GPS to TX out on the UART connector. See the LIsa/M v2 page for the UART3 pinout. Be wary of the signal levels, power consumption and voltage requirements of the GPS. You may need to modify a jumper. For software configuration details, see the GPS subsystems page.

Hope that helps.

Thanks,

-Stephen Dwyer

On Tue, Apr 2, 2013 at 8:38 PM, Jake Tarren <address@hidden> wrote:

I'm trying to get the MediaTek MT3329 GPS to work, the wiki say's it's supported: "Support is also available for MediaTek MT3329 chipsets with DIYDrones firmware."  on this page, http://paparazzi.enac.fr/wiki/Overview

but that's the only reference to it that I can see, can someone link me to a page with more info please, specifically the pinout, it's 6 pins, but my Lisa M/v2 only has 4 in UART3.

Thanks!

_______________________________________________
Paparazzi-devel mailing list
address@hidden
https://lists.nongnu.org/mailman/listinfo/paparazzi-devel

_______________________________________________
Paparazzi-devel mailing list
address@hidden
https://lists.nongnu.org/mailman/listinfo/paparazzi-devel