Re: [Paparazzi-devel] HB-Autopilot omnibus order

[antoine drouin]

Hello world

- I'm happy to see new activity on the list.
- I have not seen a hb_autopilot.h in conf/autopilot/boards - Does
paparazzi run on hb_autopilot ? if not, have you evaluated the efforts
to make it run ?
- I only have had a quick look at the tinyv3 page, but I see it's
using the max1168. It's a very good chip, but it has been obsoleted.

Regards

Poine


On Fri, May 28, 2010 at 12:13 PM, Thomas Würfl <address@hidden> wrote:
> Hello Everybody,
>
> I'd like to build my own HB-Autopilot
> (http://paparazzi.enac.fr/wiki/Tiny_v3). Since I'm not going to solder BGAs
> by myselft, I tried to get hold of prices for parts, pcbs and assembly. As
> you may know, assembly of a single pcb is quite expensive due to the high
> amount of non recurring costs (e.g. solder masks). So I ended up with appr.
> 1200€ in total including ~ 600€ non recurring costs for a single copy. Also
> this looks ok for me, I'd like to ask if somebody out there would be
> interested in an omnibus order? For ten pieces we could end up at ~660€ per
> part or even less. Prices include 19% VAT, which may not be applicable in
> your country. Please be aware that this device is likly to be subjected to
> export restictions depending on the contry of destination (US-ITAR,
> GERMAN-KrWaffKontrG and serveral others).
>
> Best Regards,
> Thomas Wuerfl
>
>
>
> _______________________________________________
> Paparazzi-devel mailing list
> address@hidden
> http://lists.nongnu.org/mailman/listinfo/paparazzi-devel
>