[Paparazzi-devel] XBee Pro RF to PC

[Reegan M]

Hello everyone!

 

It has been a while since I was last in comunication. 

 

I have reached the stage of implementing the autopilot hardware.  Before I jumped into this step I wanted to verify a few points.

 

I am using the Tiny 1.3 bundle from PPZUAV.  From what I understand I am able to flash the Tiny directly using the USB adapte.  Is this correct?  Also it seems that the connection from the the XBee Pro RF to the PC is thorugh the FTDI Utility Board.  If this is so, trying to be careful and not completely ignorant, which direction does the XBee plug into the FTDI?

 

I think that I have everything else figured out up to tis point.  Hopefully if others arise I will be able to jump though those hoops.

 

Thanks for y'all help,

Race