On Wed, Dec 30, 2009 at 2:59 PM, <
address@hidden> wrote:
> Hello,
>
> we use the 507ETTL. Perfomrance is good.
> There seems to be a problem with the configuration to be saved permanently in the module, but it does not occur after each power cycle. Only if the module is not powered up for some weeks it needs the reprogram.
> I think it will be quite some work to implement the setup in the autopilot code. It needs checks after each step and changes in the baud rate...
> I think it is a problem with the gold cap on the board being too small. Perhaps an exchange with a bigger one could solve the problem.
>
> Are you sure about the 5V power supply. Ours run with 3,3V.
>
> Regards
>
> Marc
>
> -------- Original-Nachricht --------
>> Datum: Wed, 30 Dec 2009 12:32:12 +0100
>> Von: "Prof. Dr.-Ing. Heinrich Warmers" <
address@hidden>
>> An:
address@hidden
>> Betreff: [Paparazzi-devel] Navilog-modules-for Paparazzi
>
>> Hello,
>> has someone used the Navilog GPS modules for Paparazzi?
>>
http://www.navilock.de/produkte/gruppen/13/Boards_und_Module
>> The NL-507ETTL has a u-blox lea 4 chip set and a ubx protocol (prize
>> is 35 Euro 30m x30mm 5V )
>> In the mikrokopter forum was a suggestion that the module needs
>> reprogram the parameter after power on or battery power lost.
>> Is it possible to flash the setup string in the lpc2148 memory and send
>> it after cold start?
>> The NL-552ettl ublox has a lea5 chip set but the documentation say that
>> it has only the NEMEA protocol.
>> Regards
>>
>> Heinrich Warmers
>>
>>
>
> --
> Preisknaller: GMX DSL Flatrate für nur 16,99 Euro/mtl.!
>
http://portal.gmx.net/de/go/dsl02
>
>
> _______________________________________________
> Paparazzi-devel mailing list
>
address@hidden
>
http://lists.nongnu.org/mailman/listinfo/paparazzi-devel
>
_______________________________________________
Paparazzi-devel mailing list
address@hidden
http://lists.nongnu.org/mailman/listinfo/paparazzi-devel