Hello,
please check the usb voltage on your PC.
Sometimes we have found voltages up to 8 V.
The lpc2148 is very sensitive for static voltages.
Often the connection interface pin is dead.
You can program it on a other pin.
We had to change up to 3 processors.
You can flash by the normal serial way,
if the USB connection pins are dead.
Regards
Heinirch Warmers
Loris Rion schrieb:
Hi,
We are a group of student at Isae/Supaero in Toulouse. We use a TWOG
v1 paparazzi system.
Everything was going well until this morning, we tried to flash the
board but it did not work. We tried two USB cables and checked
connections and it looks good. When we click on update on the GCS and
then we power on paparazzi, the dotted line stops for one or two
seconds and then go on to the right. Then it said "No USB device". We
tried with an old airframe and flight plan and we have the same problem.
Our board is still working (we have the datalink, GPS ...)
Thank you very much.
Loris Rion
__________ Information from ESET NOD32 Antivirus, version of virus
signature database 4080 (20090515) __________
The message was checked by ESET NOD32 Antivirus.
http://www.eset.com
_______________________________________________
Paparazzi-devel mailing list
address@hidden
http://lists.nongnu.org/mailman/listinfo/paparazzi-devel
_______________________________________________
Paparazzi-devel mailing list
address@hidden
http://lists.nongnu.org/mailman/listinfo/paparazzi-devel
__________ Information from ESET NOD32 Antivirus, version of virus
signature database 4080 (20090515) __________
The message was checked by ESET NOD32 Antivirus.
http://www.eset.com