|
From: | Rui Costa |
Subject: | Re: [Paparazzi-devel] Hardware In The Loop |
Date: | Wed, 29 Apr 2009 08:23:17 +0000 |
Hi there
I use the XBee modem, I can try with the FTDI cable latter, also with your file. wait for me until late this afternoon (time in Europe)
Regards
Chen
Date: Wed, 29 Apr 2009 08:10:22 +0000
Subject: Re: [Paparazzi-devel] Hardware In The Loop
From: address@hidden
To: address@hidden
Hi again,You tried the HITL with USB cable, datalink or FTDI cable?Can you send me your Tiny 2.11 aircraft.xml, conf.xml and control_panel.xml files?Thank you.RegardsRui Costa2009/4/28 郭 flying pig <address@hidden>
Hi there
I have try the hard ware in the loop, it works (and I believe I chat with you on the IRC on Sunday).
I also found that, you must select the HIL in the A/C (in the paparazzi center), then change the aircraft file to your own one (ie from the example to your aircraft file), then upload it with ap. start the section of HIL, it should works. I work on my Tiny1.1 and Tiny 2.11.
If you still can't get it work, let me know, I can try with your file.
Regards
Chen
Date: Sun, 26 Apr 2009 19:27:46 +0000
From: address@hidden Subject: [Paparazzi-devel] Hardware In The Loop
Hi all,
I'm trying Hardware In The Loop without success. I made what is described on wiki, but when I simulate I get no GPS and IR sensors data from simulation.
I'm using the FTDI cable. It's needed to modify the USB port baud rate to 57600? How can I do that in Ubuntu?
Best regards
Rui Costa
www.azoreanuav.com
隨身的 Windows Live Messenger 和 Hotmail,不限時地掌握資訊盡在指間— Windows Live for Mobile
_______________________________________________
Paparazzi-devel mailing list
address@hidden
http://lists.nongnu.org/mailman/listinfo/paparazzi-devel
--
Rui Costa
www.azoreanuav.com
隨身的 Windows Live Messenger 和 Hotmail,不限時地掌握資訊盡在指間— Windows Live for Mobile
_______________________________________________
Paparazzi-devel mailing list
address@hidden
http://lists.nongnu.org/mailman/listinfo/paparazzi-devel
[Prev in Thread] | Current Thread | [Next in Thread] |