On Fri, Apr 17, 2009 at 4:42 PM, Long Di
<address@hidden> wrote:
Hello all
I am doing some research on how to do the Hardware in loop simulation on Paparazzi recently, however, there is very limited resource I can start with. On the tool list of Paparazzi center, there is the Hardware in the loop selection. When I tried to run it, it shows "Run '/home/dee/paparazzo3/sw/simulators/simhitl Fatal error: exception Failure("Aircraft not found :A/C not set"), but when I opened the file simhtrl, the code there did not make much sense to me. I am wondering did anybody have some experience on this before and can help me to start? Thanks a lot.
Dee
--
Long Di, Undergraduate Research Assistant
Center for Self-Organizing and Intelligent Systems (CSOIS),
Department of Electrical & Computer Engineering
Utah State University, 4120 Old Main Hill, Logan, UT 84322-4120, USA
E: address@hidden, T: (435)754-6787
_______________________________________________
Paparazzi-devel mailing list
address@hidden
http://lists.nongnu.org/mailman/listinfo/paparazzi-devel