Re: [Paparazzi-devel] Interferences or bad contact ?

[michael evans]

check all the connections again like wires and molex. make sure the red wire from the esc is NOT connected to the tiny. space everything out as much as possible.

On Wed, Apr 15, 2009 at 4:50 AM, Antoine DURIEUX <address@hidden> wrote:

Hi,

 

I just finshed to install a Tiny 2.11 into a PiperCub, and, while performing static tests, PPZ has had a very strange behavior :

The range test is ok, but, as soon as I turn on the motor, the autopilot starts to act randomly : the servos don’t move anymore, and the motor starts and stops all the time.

Back home, I tried to simulate the problem, and it appears that as soon as I touch the servo/Rx cables or connectors, PPZ starts to act this way. I thought there must be some kind of bad contact into the wires, so I checked them, but they look like pretty ok.

 

Has anyone already met this kind of problem ?

 

Thanks by advance,

 

Antoine DURIEUX

France

_______________________________________________
Paparazzi-devel mailing list
address@hidden
http://lists.nongnu.org/mailman/listinfo/paparazzi-devel