If you're using one of the pre made files for testing, then they are linked
in a setting called 'ailevon'. Change your mixer settings to fix that.
Alston Pike
BSME 2009
The University of Alabama
address@hidden
(706) 594-2812
On Wed, Mar 18, 2009 at 7:52 PM, Aniket C. Aranake <address@hidden>
wrote:
Hello all,
I am setting up an airframe with ailerons, twin rudders, and an
elevator. The ailerons and rudders are on single servo channels via Y
cables. I am trying to test that the radio controller is working
properly. I'm seeing the following odd behavior: When I first connect
the paparazzi board, I am able to control the ailerons in both
directions (stick left and stick right). However, the elevator is
somehow coupled to the ailerons such that stick up and stick down have
a greater effect on the control surface when I am stick left and do
not work at all when I am stick right. After playing with the airframe
for a few minutes, stick right stops working altogether. At this
point, I can only use the elevator if I am all the way stick left.
This behavior is repeatable.
Any ideas what might be causing this problem?
Does anybody have a good airframe file that uses rudder, elevator,
ailerons, and a motor with tiny that I can use as starting point?
Thanks,
Aniket
_______________________________________________
Paparazzi-devel mailing list
address@hidden
http://lists.nongnu.org/mailman/listinfo/paparazzi-devel
_______________________________________________
Paparazzi-devel mailing list
address@hidden
http://lists.nongnu.org/mailman/listinfo/paparazzi-devel