On Wed, Jul 2, 2008 at 10:48 AM, Jose Luis Cortes <
address@hidden> wrote:
Hi to all!
I have start to design a board (only to spend sunday afternoom) based
on tiny 2 protel, i am thinking about a small PCB with all common uav
sensors.
it is only an idea, but i am willing to build a project like this.
the board could be about 40 x 55 mm with next components:
- all tiny components excepting GPS (i preffer to use a GPS module to
more flexible placement)
- inertial sensors for 6DOF (without any vertical board!!!
MMA7260Q+IDG-300+MLX90609)
- Absolute pressure (altitude) - MPX4100A
- Diferential pressure (pitot-tube) - MPXV5010DP
- Xbee Pro (100mw)
- 2 axis compass MH55B
- 1 x GPS (uart) input for a external any nmea gps
...
my IMU proposal is very compact and have no vertical boards, i have
allready tested it - this small board have a interesting combination
of inertial sensor to complete 6DOF in order to avoid vertical boards:
Acelerometer (X,Y,Z) - MMA7260Q (analog output) or LIS3LV02DQ (SPI output)
Gyros (X,Y) - IDG-300 (3 gyros in the same chip analog output)
Gyro (Z) - MLX90609 (analog and SPI output)
I attach a screenshot with a very very preview of this board.
Jlcortex
_______________________________________________
Paparazzi-devel mailing list
address@hidden
http://lists.nongnu.org/mailman/listinfo/paparazzi-devel