I thought about it all night, and then in the morning, BINGO. I looked at GPS reset and checked the little barrier diode, sure enough, I had it reversed! All working now, bootloader is loaded.
----- Original Message ----
From: "address@hidden" <address@hidden>
To: address@hidden
Sent: Tuesday, 6 May, 2008 2:16:51 AM
Subject: Re: Re: [Paparazzi-devel] Bootloader error
Hi Uttam,
> I get the following on a new Tiny 2.1 board I just assembled:
just to make sure on DOWNLOAD:
- BOOT (P0.14) is low
-
GPS_RESET (u-blox pin 10) is low
during that. If you connected BOOT to RTS of the serial PC port, make
sure you reset/power the board after starting the lpc21isp download (as
there is no LPC_RESET possibly connected to DTR).
Martin
_______________________________________________
Paparazzi-devel mailing list
address@hiddenhttp://lists.nongnu.org/mailman/listinfo/paparazzi-devel