[Paparazzi-devel] Tiny13 Power

[Matthew Currie]

Group,


 In manual mode, if I cycle the sticks quite fast it seems to reboot 
the Tiny13 which will obviously not end well in the air.  This is very 
consistent and I can reboot it within seconds every time.  Before I 
embark on a deep analysis of power rails here is there any experience 
anyone may have for me?  I want to think it is not a thermal issue since 
I can reboot it in a mere second repeatedly, or leave it running for 10 
minutes and reboot it by cycling the sticks.  I am sure I changed the 
tantalum cap to low-ESR which was referenced in the wiki as being 
incorrect.  I am running the Tiny13 from a 3S1P (11.5V at this point) 
and only have 2 Hitec HS-55 servos installed.  Thanks.


Regards,
Matthew