Hi all,
Thanks to Pascal, the IR sensors are all caliberated and working fine. How do I use the modems now? I connected the stand alone modem to the
laptop USB and it powered on OK. I then plugged the 9Xtend into the
serial header ( Pins used on the 9Xtend were GND, VCC +% from Tiny, RX,
TX and shutdown connected to +5V. ) When I power up, current draw has
increased by around 200ma, the 2 modems seem to sync too ( Other lights
light up on the stand alone modem ) Do I run the Maxstream session at
9600? I tried running the Maxstream session at 57600, and restarting
link at 9600, but it says Xbee cannot be found? What do I do?
Airframe file is funjet1.xml
-Thanks
Uttam