Re: [Paparazzi-devel] Tiny 2 and IR, gyro settings

[Michel GORRAZ]

Don't plug the +5v  from Tiny on the FTDI cable : you just need to connect GND, TX and RX.
(The FTDI cable is self-powered by the USB bus)

@+
Michel

2008/1/16, Michel GORRAZ < address@hidden>:

Don't plug the +5v  from Tiny on the FTDI cable : you just need to connect GND, TX and RX.

@+
Michel

2008/1/15, Uttam Chandrashekhar < address@hidden>:

Would that be the GND, +5V from Tiny, RX and TX going to the FTDI cable?

-Thanks,
Uttam

----- Original Message ----
From: Uttam Chandrashekhar <address@hidden >
To: address@hidden
Sent: Tuesday, January 15, 2008 9:36:53 PM
Subject: Re: [Paparazzi-devel] Tiny 2 and IR, gyro settings

What connections do I need from the Tiny Serial port to the USB to serial adapter to try the serial protocol?


-Thanks,
Uttam

----- Original Message ----
From: " address@hidden" <address@hidden>
To: address@hidden
Sent: Tuesday, January 15, 2008 6:50:20 PM
Subject: RE: [Paparazzi-devel] Tiny 2 and IR, gyro settings

1 of them is an ADXRS150 or 300 Im not sure.  The other is a small PCB with a mini USB connector on it to program the AP.  If you blow up the picture full scale(it gets sized by my browser anyways) you can see the difference between the 2.

 

AJ

---

Be a better friend, newshound, and know-it-all with Yahoo! Mobile. Try it now.

---

Be a better friend, newshound, and know-it-all with Yahoo! Mobile. Try it now.

_______________________________________________
Paparazzi-devel mailing list
address@hidden
http://lists.nongnu.org/mailman/listinfo/paparazzi-devel