These are the switches available on the T6Xhs TX:
Switch A- Elevator dual rate
Switch B- Airbrake switch
Switch C- Aileron dual rates
Switch D- Elevator to Flap mixing switch
Switch E- Landing gear switch
Switch F- Trainer
Ch6 Knob- Flap/Flap trim in flaperon function
All are 2 way switches. How do I go about adding a 3 way switch to my TX, Pascal?
-Thanks,
Uttam
----- Original Message ----
From: "
address@hidden" <
address@hidden>
To:
address@hiddenSent: Sunday, January 6, 2008 6:17:26 AM
Subject: RE: [Paparazzi-devel] Tiny
v2
I definitely suggest a switch. If you have some sort of issue that requires taking the plane out of the current mode, turning a knob is not a good way to do so. The last thing you want is to go to manual when you wanted auto1, or to not get out of the mode to begin with because you didnt dial in the right value.
AJ
-------- Original Message --------
Subject: Re: [Paparazzi-devel] Tiny v2
From: Pascal Brisset <
address@hidden>
Date: Sat, January 05, 2008 11:28 am
To: address@hidden
Uttam Chandrashekhar wrote:
> Thanks Pascal. I have a Futaba T6Xhs programmable TX, but I don't see
> a three position switch:( It has a Flap knob on channel 6 though. What
> do I do? Can I use this TX with the paparazzi?
No cursor available ?
It is usually easy to add a 3 position switch to a transmitter, using
resistor bridges ... and a scope to produce the appropriate signal.
--Pascal
_______________________________________________
Paparazzi-devel mailing list
Paparazzi-devel@nongnu.org
http://lists.nongnu.org/mailman/listinfo/paparazzi-devel
2_position_3_postion_switch.png