I don't have a 3 position switch on my TX, maybe because its sort of old? I only have switches for idle up, a switch for retracts down, one dial for flaps, and dual rate 2 position switches. No 3 position switch. Can any one recommend a TX with a 3 position switch? Where are the 3 position switches used on the TX?
Sorry for so many q's!
-Thanks,
Uttam
----- Original Message ----
From: "address@hidden" <address@hidden>
To: address@hidden
Sent: Sunday, January 6, 2008 6:17:26 AM
Subject: RE: [Paparazzi-devel] Tiny v2
I definitely suggest a switch. If you have some sort of issue that requires taking the plane out of the current mode, turning a knob is not a good way to do so. The last thing you want is to go to manual when you wanted auto1, or to not get out of the mode to begin with because you didnt dial in the right value.
AJ
-------- Original Message --------
Subject: Re: [Paparazzi-devel] Tiny v2
From: Pascal Brisset <address@hidden>
Date: Sat, January 05, 2008 11:28 am
To: address@hidden
Uttam Chandrashekhar wrote:
> Thanks Pascal. I have a Futaba T6Xhs programmable TX, but I don't see
> a three position switch:( It has a Flap knob on channel 6 though. What
> do I do? Can I use this TX with the paparazzi?
No cursor available ?
It is usually easy to add a 3 position switch to a transmitter, using
resistor bridges ... and a scope to produce the appropriate signal.
--Pascal
_______________________________________________
Paparazzi-devel mailing list
Paparazzi-devel@nongnu.org
http://lists.nongnu.org/mailman/listinfo/paparazzi-devel