Re: [Paparazzi-devel] FBW and AP...

[Alexis Lussier Desbiens]

Ok... I found that I have issue much sooner than that! I tried to
enable the "debug" mode on the FBW by adding the line <define
name="TELEMETRY_MODE_FBW" value="1"/> in my airframe file. But I think
I don't put it in the right section because it is not doing
anything...

Anyway, I added the PPM signal to the "default" mode and I only get
0,0,0,0,0... Can someone tell me which file I should look at to make
it work? Because right now... it doesn't seem to do much!

Thanks!

   Alexis

On 10/6/07, Pascal Brisset <address@hidden> wrote:
> Hi Alexis,
>
> Alexis Lussier Desbiens wrote:
> > Hey,
> >
> > I got a really stupid question... how do you switch between FBW mode
> > and AP mode in paparazzi? Is it over the serial link? With the RC
> > controller?
> >
>  Terminology: FBW and AP are processes, not modes. FBW handles the RC
> reception and the servo commands while AP handles ... the rest. On a
> dual processor board, these processes are distributed over the two CPUs.
> On a single processor board (e.g. the Tiny), these processes are only
> logically splitted.
>  The current implemented "modes" are MANUAL, AUTO1, AUTO2, HOME and
> NOGPS. The MANUAL mode is implemented in the FBW process. All the other
> modes require FBW and AP.
>
> --Pascal
>
> >      Alexis
> >
> >
> > _______________________________________________
> > Paparazzi-devel mailing list
> > address@hidden
> > http://lists.nongnu.org/mailman/listinfo/paparazzi-devel
> >
>
>
>
> _______________________________________________
> Paparazzi-devel mailing list
> address@hidden
> http://lists.nongnu.org/mailman/listinfo/paparazzi-devel
>


-- 
http://mecano.gme.usherb.ca/~alussierdesbiens
"De' remi facemmo ali"