RE: [Paparazzi-devel] Battery and servo problems

[akochevar]

It sounds to me like you are using the wrong configuration for the Tiny version you have.  What version of the Tiny are you using?  Take a look at the funjetmm.xml as a good setup for the Tiny 1.1,  at least I think its set up for a 1.1.  If its somethign different then look for an example airframe for those(0.9 and 0.99)  these boards are layed out differently and therefore have slightly different servo driving code.

 

Anton

-------- Original Message --------
Subject: [Paparazzi-devel] Battery and servo problems
From: "Dmytriy Stepchenkov" <address@hidden>
Date: Tue, September 11, 2007 9:13 pm
To: address@hidden

Hello everyone.

We are currently expiriencing a few problems with Tiny - first is that battery voltage that Tiny outputs on its telemetry messages is different from the one that it is actually supplied with ( supplied  11.11V paparazzi telemetry  7.9V ). We measured the voltage directly at the divider on the board - and it is right - so i suspect it is a software problem
 
The other problem is that we can't move any servos in any of the flight modes .

Does anyone knows what might be causing those problems ?

Thanks
Dmytriy

Save £5 on your monthly line rental with Flext from T-Mobile. £180 of value for just £30 per month click here

---

_______________________________________________
Paparazzi-devel mailing list
Paparazzi-devel@nongnu.org
http://lists.nongnu.org/mailman/listinfo/paparazzi-devel