Re: [Libreboot] X200 nvramtool not working. "No CMOS Option Table"

[Daniel Tarrero]

:S maybe you have to rebuild

check for dependencies because USE_OPTION_TABLE seem dependant on
HAVE_OPTION_TABLE

... so regardless you had this flag enabled (=yes) maybe there are other
flags you have to enable too in order to use this "option table"

i have no idea xD good luck! :)




El jue, 21-01-2016 a las 17:37 +0100, Robin Vobruba escribió:
> i have an x200 with libreboot na dgrub, nad when i try these steps, i
> get:
> nvramtool: /coreboot/util/nvramtool/accessors/cmos-mem.c:17:
> mem_hal_read: Assertion `mem_hal_data != (unsigned char*)-1' failed.
> 
> (for both the commands)
> 
> using the coreboot self-compiled nvramtool
> 
> 
> 2016-01-21 15:34 GMT+01:00 Datentonne <address@hidden>:
>         Hi,
>         
>         i am using Libreboot + grub on a X200, everything is working
>         fine. Except one thing. I wan't to disable the annoying
>         Low-Battery-Beep and followed the guide described here.
>         https://libreboot.org/docs/misc/#powerbeeps
>         
>         But i can't use nvramtool. The ouput is:
>         "nvramtool: CMOS option table not found in coreboot table.
>         Apparently, the coreboot installed on this system was built
>         without specifying HAVE_OPTION_TABLE."
>         
>         Config from the .rom says "HAVE_OPTION_TABLE=yes"
>         
>         Can anyone with a X200 confirm this or has maybe a solution
>         for me.
>         
>         Best Regards.
>         
>         Herr G.
>         
>         
>         P.S.: Please forgive my English, its not my native language
>         and i am posting on a Mailinglist the first time.
>         
>         
>         
>         
>         
> 
>