[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: adding/removing ntrip devices via gpsdctl?
From: |
Gary E. Miller |
Subject: |
Re: adding/removing ntrip devices via gpsdctl? |
Date: |
Thu, 20 Oct 2022 15:41:50 -0700 |
Yo Michael!
On Thu, 20 Oct 2022 23:35:24 +0200
Michael Haberler <haberlerm@gmail.com> wrote:
> > I do notice this from the one where ntrip is "working":
> >
> > Oct 20 21:51:58 oe-sox gpsd[12026]: gpsd:WARN: NMEA0183: TXT:
> > Error: txbuf alloc
> >
> > That means you are overflowing the TX buffer in the u-blox. I
> > assume this is because you are using the serial port, instead of
> > the USB port, on the F9P.
>
> I'm positive I only used the USB port during this test, and I have
> seen these messages using only the USB port
Good.
> I still have a FTDI USB/serial dongle connected to UART1 but this
> port was idle during the tests
The F9P does not know is something is plugged in to your serial port
or not. It just sends data there by default. Check you configuration,
you prolly should configure that serial port as off.
> gpsd with ntrip goes flying for a few days ;)
Hopefully not around DFW...
RGDS
GARY
---------------------------------------------------------------------------
Gary E. Miller Rellim 109 NW Wilmington Ave., Suite E, Bend, OR 97703
gem@rellim.com Tel:+1 541 382 8588
Veritas liberabit vos. -- Quid est veritas?
"If you can't measure it, you can't improve it." - Lord Kelvin
pgpHIpNznEKxG.pgp
Description: OpenPGP digital signature