Re: el3

[Schahzad Z. Choudhry]

----- Original Message ----- 
From: "Daniele Forsi" <address@hidden>
To: "Discussion forum for gnokii users." <address@hidden>
Sent: Sunday, May 27, 2007 10:15 PM
Subject: Re: el3


> address@hidden wrote:
>
> > GNOKII Version 0.6.14
>
> > # where to log the debug output (on: stderr, off: /dev/null)
> > #debug = on
>
> set debug = on in gnokiirc and post the output
>
> you should consider downloading the sources from the CVS repository and
> posting the debug log of that version (0.6.16cvs), because if a patch is
> needed it will be against the CVS version, and might not work your old one
>
> see http://www.gnokii.org/cvs.shtml
>
> --
> Daniele
>
>
> _______________________________________________
> gnokii-users mailing list
> address@hidden
> http://lists.nongnu.org/mailman/listinfo/gnokii-users




Dear Daniele,
Thanks for your help.


here i am sending you the logs,


Note
i have reduced the number of time following lines appear to increase the 
readability of logs.

Serial write: transmitter busy, waiting
Serial write: transmitter ready
Regards






> address@hidden root]# /usr/local/bin/gnokii --identify
GNOKII Version 0.6.14
LOG: debug mask is 0x1
Lockfile /var/lock/LCK..ttyUSB0 is stale. Overriding it..
phone instance config:
model: 6810
port_device: /dev/ttyUSB0
connection_type: 2
init_length: 2
serial_baudrate: 9600
serial_write_usleep: -1
hardware_handshake: 0
require_dcd: 0
smsc_timeout: 100
connect_script:
disconnect_script:
rfcomm_cn: 1
sm_retry: off
Connecting
Serial device: opening device /dev/ttyUSB0
Serial device: setting RTS to low and DTR to low
Serial device: setting RTS to high and DTR to high
Serial device: setting speed to 19200
Switching to FBUS mode
Serial device: setting speed to 115200
Serial write: transmitter busy, waiting
Serial write: transmitter ready
Serial write: transmitter busy, waiting
Serial write: transmitter ready
Serial write: transmitter busy, waiting
Serial write: transmitter ready
Serial write: transmitter busy, waiting
Serial write: transmitter ready
SM_Block: exiting the retry loop
Message sent: 0x1b / 0x0006
00 01 00 07 01 00                               |
SM_Block: exiting the retry loop
Message sent: 0x1b / 0x0006
00 01 00 07 01 00                               |