Re: Receiving calls

[Daniele Forsi]

Mattia Martinello wrote:

> I own a Siemens TC35i GPRS modem which works on a serial port.
> There is a way to make some actions when I receive a call (without 
> answer) from this modem?

IF it supports AT#CID=1 then you don't need gnokii to handle the caller 
id and you can use any program that works with ordinary modems; you can 
try that in minicom

> Is there a way to make this with Gnokii? 

you could pipe and parse the output of gnokii --monitor

more easily, I've written a small program that just waits for a call and 
prints the caller id; you can find it in the CVS and in the next release 
of gnokii as utils/waitcall but I think that right now it doesn't work 
with your modem because I just tried it with a Nokia 8310 in AT mode and 
it does NOT get the call notification, while gnokii --monitor gets it 
but without the caller number (I see that AT+CLIP is not sent by the driver)

if your GPRS modem supports the following commands in minicom, then 
chances are that you can use utils/waitcall once I dig into this at+clip 
issue

at+crc=1
OK
at+clip=1
OK
then I call it and I get
+CRING: VOICE

+CLIP: "+393<omitted>",145

--
Daniele