Re: packet_loopback_hier OTA problem

[Marcus Müller]

Ah, interesting; how much data did you send out with your previous message 
period time?

DISCLAIMER: Any attached Code is provided As Is. It has not been tested or 
validated as a product, for use in a deployed application or system, or for use 
in hazardous environments. You assume all risks for use of the Code. Use of the 
Code is subject to terms of the licenses to the UHD or RFNoC code with which 
the Code is used. Standard licenses to UHD and RFNoC can be found at 
https://www.ettus.com/sdr-software/licenses/.

NI will only perform services based on its understanding and condition that the 
goods or services (i) are not for the use in the production or development of 
any item produced, purchased, or ordered by any entity with a footnote 1 
designation in the license requirement column of Supplement No. 4 to Part 744, 
U.S. Export Administration Regulations and (ii) such a company is not a party 
to the transaction.  If our understanding is incorrect, please notify us 
immediately because a specific authorization may be required from the U.S. 
Commerce Department before the transaction may proceed further.

On 07.07.21 23:06, Jack wrote:
> Running it at 1MS/s didnt yield particularly good results, however using 
> 2MS/s along
> with increasing the message period time to around 150ms gives some progress. 
> Received
> packets are few and far between, along with a very out of phase 
> constellation. The time
> sink labeled rx is directly after the UHD sink and before the multiply 
> constant, and
> shows an pretty expected amplitude. The out of phase constellation was the 
> original
> problem I stumbled upon when using 3.8 and 3.9 and what caused me to try the 
> OFDM
> example before later updating to 3.10. In my experience, changing values of 
> the PCS does
> not bring the constellation back into phase while OTA.
>
> https://imgur.com/a/ehdr7lX
>