[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [Xlog-discussion] Hamlib error in 1.9
From: |
John B. Egger |
Subject: |
Re: [Xlog-discussion] Hamlib error in 1.9 |
Date: |
Wed, 04 Feb 2009 21:41:45 -0500 |
User-agent: |
Thunderbird 2.0.0.19 (X11/20090105) |
John B. Egger wrote:
I just installed 1.9 and after its initial frequency reading get a
"There was an error communicating with your rig, hamlib has stopped."
I'm using an Orion II. Running rigctl -r /dev/ttyS1 -m 1608 and
entering "f" gives the correct frequence, "m" the correct mode and
passband.
I installed Xlog 1.9 using Synaptic, from the Debian sid repository. I
can hunt down the gtk version, etc., if needed.
Perhaps this isn't the place for this question but all I could find in
sourceforge/hamlib was a developers' forum and I'm a long way from
being a developer.
PS: This is hamlib.out:
rig:rig_init called
rig:rig_open called
TX 3 bytes
0000 3f 56 0d ?V.
RX 15 characters
0000 56 65 72 73 69 6f 6e 20 32 2e 30 33 39 64 2dTX 3 bytes
0000 3f 53 0d ?S.
RX 4 characters
0000 35 36 36 0d 566.
** retry after delay (io=12, retry=0) **
RX 12 characters
0000 40 53 52 4d 30 36 39 53 30 33 32 0d @SRM069S032.
TX 3 bytes
0000 3f 53 0d ?S.
RX 12 characters
0000 40 53 52 4d 30 36 39 53 30 33 32 0d @SRM069S032.
tt565_get_level: unsupported level 1073741824
rig:rig_close called
rig:rig_cleanup called
I hope that is helpful...
--
John
Registered Linux User #291592
Klikit-Linux-0.2-RC3