[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Xlog-discussion] Hamlib in 1.8: No QSO-pane data

From: Joop Stakenborg
Subject: Re: [Xlog-discussion] Hamlib in 1.8: No QSO-pane data
Date: Sun, 31 Aug 2008 10:07:15 +0200

Op zaterdag 30-08-2008 om 19:35 uur [tijdzone -0400], schreef John B.
> I just updated Xlog 1.7 to 1.8. Hamlib provides a frequency readout in 
> my statusbar, as I requested, but Ctrl-K adds no information from the 
> transceiver to the QSO pane (only the date and time).
> I'm using the same parameters (selection of radio and device) as in 1.7 
> (which I still have installed on a laptop, so comparisons are easy). The 
> ChangeLog didn't seem to show anything related to this.
> Anyone else experiencing this, or have I misconfigured 1.8 somehow? I 
> compiled it from the .tar.gz file, since I use a Debian (Kubuntu-based) 
> system. Everything looks fine, except that Ctrl-K doesn't pull in the data.

Rob, KL7NA reported the same problem to me in a private mail. I will
have a look at it later this week and when fixed, will make a 1.8.1

Joop PG4I

reply via email to

[Prev in Thread] Current Thread [Next in Thread]