[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Uisp-dev] Writing the fuse bits with avr910?

From: Theodore A. Roth
Subject: Re: [Uisp-dev] Writing the fuse bits with avr910?
Date: Thu, 20 Feb 2003 08:40:20 -0800 (PST)

On Thu, 20 Feb 2003, Bernd Trog wrote:

:) Hi,
:) anybody know which avr910-firmware version supports
:) reading and writing fuse bits with a ATmega16?
:) >uisp-20021201/src/uisp -v=3 -dprog=avr910 -dserial=/dev/ttyS2  -dpart=S8515
:) --rd_fuses
:) Programmer Information:
:)   Software Version: 2.0, Hardware Version: 1.0
:) Address Auto Increment Optimization Enabled
:) Vendor Code: 0x1e
:) Part Family: 0x94
:) Part Number: 0x03
:) Atmel AVR ATmega16 is found.
:) Page Write Enabled, size=128
:) FLASH Write Delay (t_wd_flash): 12500 us
:) EEPROM Write Delay (t_wd_eeprom): 25000 us
:) Device is not responding correctly.

Can you run this again with -v=4 and post the output?


reply via email to

[Prev in Thread] Current Thread [Next in Thread]