David Karr <davidmichaelkarr@gmail.com> writes:
Hi David,
> Ok. Here are the exact steps:
Sorry, that doesn't work for me.
> 1. emacs -Q
> 2. visit-file .emacs
> 3. Select entire file
> 4. eval-region
I have combined 3. and 4. to 'eval-buffer'. I get the error
--8<---------------cut here---------------start------------->8---
Loading delsel...done
progn: Cannot open load file: No such file or directory, icomplete+
--8<---------------cut here---------------end--------------->8---
I would know what to do, but that's too time consuming. I don't intend
to install further packages on my laptop. Please strip your .emacs to
the absolute minimum. Change also lines like
--8<---------------cut here---------------start------------->8---
(load-library "buffer-cycle.el")
(load-library "cycle-shell.el")
--8<---------------cut here---------------end--------------->8---
to something which will work out-of-the-box, because the tmp directory,
where I have saved your files, does not belong to my load-path.
Ok, perhaps this will work better. I'm attaching a gzipped tar file with three files, a slightly modified .emacs file, and the two custom el files. Unpack it somewhere, and cd into the directory with the three files.
Then run the following command line:
emacs -Q -l .emacs
When it finishes loading, follow the "good" test case by doing:
C-x C-f /ssh:<userid>@<host>:<path>
After a few seconds, the file appears.
The "bad" test case is the "good" test case, with the following key sequence done first:
C-x C-e
This will create and render a shell buffer. Proceed with the rest of the "good" test case. This will eventually time out.
Best regards, Michael.
emacstest.tar.gz