Re: [Tlf-devel] Pre-release of TLF-1.0.0

[Rein Couperus]

I did the following to get tlf-1.0.0pre going with hamlib:

* check if libhamlib-dev is on your system, if not sudo apt-get install 
libhamlib-dev
* in the TLF-1.0.0pre directory, do a make clean
* ./configure --enable-hamlib
* make
* sudo make install

This is for Debian based systems, for other distros do something similar :)

This works fine for my K3, I had to disable dts-rts PTT on the K3.

Here is the screen dump:

       Welcome to tlf-1.0.0pre by PA0R!!

reading country data
reading configuration data
Opening config file logcfg.dat
reading contest rules file: /usr/local/share/tlf/rules/cqww
Using contest rules file: /usr/local/share/tlf/rules/cqww
reading callmaster data
Cannot find initial exchange file
No initial exchange file
HAMLIB defined
Rignumber is 221
Rig speed is 4800
Trying to start rig ctrl
freq = 14008000
keyer is cwdaemon

73,

Rein PA0R

[PA0R on twitter]

> -----Ursprüngliche Nachricht-----
> Von: "Rob Vance" <address@hidden>
> Gesendet: 04.12.09 20:23:44
> An: address@hidden
> Betreff: Re: [Tlf-devel] Pre-release of TLF-1.0.0

Hi Dave,
> 
> Thanks for the tip. In fact, I did not have that package on my system.
> I downloaded and installed it. Then I ran the ./configure make sudo 
> make install process and reran tlf. Same results. Do you think I 
> should reboot? Was recompiling necessary? Did I do it correctly?
> 
> Thanks.
> 
> Rob, N6ROB
> -----Original Message-----
>  *From*: Dave Kufta <address@hidden>
>  *To*: address@hidden
>  *Subject*: Re: [Tlf-devel] Pre-release of TLF-1.0.0
>  *Date*: Fri, 4 Dec 2009 18:39:02 +0000
> 
> On Friday 04 December 2009 05:56:33 pm Rob Vance wrote: > Rein, > > I 
> have successfully compiled this version (1.0.0) on Ubuntu 9.04. No > 
> complaints from the compiler. > > A couple of early observations: > > 
> - I cannot get the TLF to control the rig. rigctl from the command 
> line > tested successfully on my radio (model 204 on Hamlib 1.2.8). 
> Verbose > mode (tlf -v) tells me... > > Welcome to tlf-0.9.31 by PA0R!
> ! > > reading country data > reading configuration data > Opening 
> config file logcfg.dat > reading contest rules file: rules/10M_ver1 > 
> Using contest rules file: rules/10M_ver1 > reading multiplier data > 
> reading callmaster data > Cannot find initial exchange file > No 
> initial exchange file > No Hamlib library, using native driver > 
> Rignumber is 204 > Rig speed is 57600 > Keyer is cwdaemon > A: Phone 
> message #1 is /home/rob/tlf/sounds/n6rob.ogg > > I have also started 
> with tlf -d (debug mode for rigctl) but the output > is exactly the 
> same as tlf -v. > > The rig control portion of logcfg.dat says... > # 
> # > # RADIO CONTROL # > # (comment out if not present) # > # Rigmodel 
> = Hamlib index, here # > # for ten tec OMNI VI # > ###################
> ############## > # > RADIO_CONTROL > RIGMODEL=204 > RIGSPEED=57600 > 
> RIGPORT=/dev/ttyS0 > #RIGPORT=/dev/ttyUSB2 > # > SSBMODE > # > #RIT_
> CLEAR > # > SHOW_FREQUENCY > # > > I have verified using rigctl from 
> the command line that /dev/ttyS0 is > the correct port address, and 
> the rig is set to 57.6K. > > - I can't get the voicekeyer to work, 
> but I speculate that it may be > because the radio is not communicating
>  effectively with tlf - but I am > not certain of this. The CW keyer 
> plays the side tone just fine. I > haven't tested the lp0 with a 
> voltmeter to see if it's actually keying > the rig (cwdaemon 0.9.4 
> had a problem with this before). But I will > test that later. I have 
> tested the audio files using the play from the > command line with 
> the exact same paths as I used in logcfg.dat and they > play 
> correctly. > > I have attached my logcfg.dat and rule files; but I 
> don't know if the > list server will accept them. > > I am hoping to 
> use TLF for the ARRL 10M contest in a couple of weeks, > any guidance 
> before then would be appreciated. As always, thank you > very much 
> for creating tlf! > > 73, > > Rob, N6ROB > > > -----Original Message--
> --- > From: Rein Couperus <address@hidden> > To: address@hidden
> org> Subject: [Tlf-devel] Pre-release of TLF-1.0.0 > Date: Fri, 04 
> Dec 2009 15:14:33 +0100 > > > A prerelease of TLF-1.0.0 is available 
> at > http://hermes.esrac.ele.tue.nl/TLF/alpha for testing. > > This 
> release should prevent segfaults on ubuntu 9.04 and 9.10. > > Several 
> bugs were fixed by NC1C and DL1JBE. > > When you want to compile it 
> on UBUNTU, you will need to install > build-essential, libncurses5-
> devel, and automake 1.9, then do a > ./configure, make and sudo make 
> install. > > happy testing, 73 > > Rein PA0R > Rob, Do you have 
> hamlib-devel package on your system ? The compiler seems to not 
> notice hamlib.pc Dave, [n3meq] _______________________________________
> ________ Tlf-devel mailing address@hidden://lists.
> nongnu.org/mailman/listinfo/tlf-devel_________________________________
> ______________ Tlf-devel mailing list address@hidden http://
> 
> lists.nongnu.org/mailman/listinfo/tlf-devel

-- 
http://pa0r.blogspirit.com

-- 
http://pa0r.blogspirit.com