[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [Qemu-ppc] [PATCH v2 00/16] hw: Use object_initialize_child for corr
Re: [Qemu-ppc] [PATCH v2 00/16] hw: Use object_initialize_child for correct reference counting
Fri, 17 May 2019 19:06:36 +0100
On Fri, 17 May 2019 at 18:56, Eduardo Habkost <address@hidden> wrote:
> On Fri, May 17, 2019 at 12:32:18PM +0200, Philippe Mathieu-Daudé wrote:
> > Hi Eduardo,
> > On 5/7/19 6:34 PM, Philippe Mathieu-Daudé wrote:
> > > Hi,
> > >
> > > This series looks at Eduardo suggestions from 
> > > and Thomas commit aff39be0ed97 to replace various
> > > object_initialize + qdev_set_parent_bus calls by
> > > sysbus_init_child_obj().
> > Do you think you can take this series?
> > Else, via which tree it should go?
> I was expecting the maintainers of each architecture to apply the
> patches for their areas.
This in my experience rarely happens, because splitting up
a patchset is effort and there's a coordination problem
working out who's going to take which patches -- it's why it
works better to have several series each of which covers one
submaintainer's area, rather than one big series which then
doesn't have an obvious path into the tree.
(Personally I also tend to treat omnibus patch series as
"somebody else's problem" whereas patch series that are
mostly or entirely arm changes go on my list as needing
to be dealt with...)
> Are the arm, microblaze, mips, and ppc maintainers OK with that?
No objections for arm if the patches have been reviewed.
- [Qemu-ppc] [PATCH v2 14/16] hw/microblaze/zynqmp: Use object_initialize_child for correct ref. counting, (continued)