[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[Qemu-ppc] [PULL 17/40] hw/ppc/spapr: Fix error message when firmware co

From: Alexander Graf
Subject: [Qemu-ppc] [PULL 17/40] hw/ppc/spapr: Fix error message when firmware could not be loaded
Date: Wed, 3 Jun 2015 23:45:18 +0200

From: Thomas Huth <address@hidden>

When specifying a non-existing file with the "-bios" parameter, QEMU
complained that it "could not find LPAR rtas". That's obviously a
copy-n-paste bug from the code which loads the spapr-rtas.bin, it
should complain about a missing firmware file instead.
Additionally the error message was printed with hw_error() - which
also dumps the whole CPU state. However, this does not make much
sense here since the CPU is not running yet and thus the registers
only contain zeroes. So let's use error_report() here instead.
And while we're at it, let's also bail out if the firmware file
had zero length.

Signed-off-by: Thomas Huth <address@hidden>
Signed-off-by: David Gibson <address@hidden>
Signed-off-by: Alexander Graf <address@hidden>
 hw/ppc/spapr.c | 6 +++---
 1 file changed, 3 insertions(+), 3 deletions(-)

diff --git a/hw/ppc/spapr.c b/hw/ppc/spapr.c
index 971cb5f..9c05787 100644
--- a/hw/ppc/spapr.c
+++ b/hw/ppc/spapr.c
@@ -1641,12 +1641,12 @@ static void ppc_spapr_init(MachineState *machine)
     filename = qemu_find_file(QEMU_FILE_TYPE_BIOS, bios_name);
     if (!filename) {
-        hw_error("Could not find LPAR rtas '%s'\n", bios_name);
+        error_report("Could not find LPAR firmware '%s'", bios_name);
     fw_size = load_image_targphys(filename, 0, FW_MAX_SIZE);
-    if (fw_size < 0) {
-        hw_error("qemu: could not load LPAR rtas '%s'\n", filename);
+    if (fw_size <= 0) {
+        error_report("Could not load LPAR firmware '%s'", filename);

reply via email to

[Prev in Thread] Current Thread [Next in Thread]