Re: [Qemu-discuss] help using qemu to emulate raspberry pi2

[Jakob Bohm]

On 09/08/2015 15:34, James wrote:
> This is what the console on the host says (it doesn't loop):
>
>
> Uncompressing Linux... done, booting the kernel.
>
> Raspbian GNU/Linux 7 (none) ttyAMA0
>
> (none) login: pi
> Password:
> Linux (none) 3.2.0 #1 Sun Jan 29 03:14:15 CST 2012 armv6l
>
> The programs included with the Debian GNU/Linux system are free software;
> the exact distribution terms for each program are described in the
> individual files in /usr/share/doc/*/copyright.
>
> Debian GNU/Linux comes with ABSOLUTELY NO WARRANTY, to the extent
> permitted by applicable law.
>
> NOTICE: the software on this Raspberry Pi has not been fully configured.
> Please run 'sudo raspi-config'
>
>
> Raspbian GNU/Linux 7 (none) ttyAMA0
>
> (none) login:
The following assumes Raspian 7 uses a traditional sysv
init process, just like Debian 7.

From the emulated ttyAMA0, try looking at the contents
of /etc/inittab and try to see which line looks most
like it could have "Id 1" .

That is the process that keeps failing to run so fast
that /sbin/init refuses to relaunch it until a 5
minute cool off period.

Then look in /var/log/syslog, /var/log/messages etc.
for reasons why that process refuses to run.

Enjoy

Jakob
--
Jakob Bohm, CIO, Partner, WiseMo A/S.  https://www.wisemo.com
Transformervej 29, 2860 Søborg, Denmark.  Direct +45 31 13 16 10
This public discussion message is non-binding and may contain errors.
WiseMo - Remote Service Management for PCs, Phones and Embedded