Re: [Qemu-discuss] FW: How to setup qemu as a server with different subdomain on a host server?

[Jakob Bohm]

On 4/10/2013 3:56 PM, Tony Su wrote:
> Interesting, if you say adding both wlan0 and eth0 to br0 should work, 
> when I set that up networking didn't work as expected.
>
> I guess I'll try again...
It only works if they are the same network (same IP addresses, a 
traceroute from one to the other should not show a router hop on the 
way), and only if they are only combined on ONE machine on the entire 
network (typically the router), loops in networks tend to work very badly.

I mentioned that they are combined on routers just to show why I think 
that adding wlan0 + someQemuMachine to a bridge should work.


Enjoy

Jakob
--
Jakob Bohm, CIO, Partner, WiseMo A/S.  http://www.wisemo.com
Transformervej 29, 2730 Herlev, Denmark.  Direct +45 31 13 16 10
This public discussion message is non-binding and may contain errors.
WiseMo - Remote Service Management for PCs, Phones and Embedded