[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Qemu-discuss] Q35 chipset

From: Dmitry Zamaruev
Subject: Re: [Qemu-discuss] Q35 chipset
Date: Thu, 10 Jan 2013 22:30:34 +0200

On Sat, Jan 5, 2013 at 11:38 AM, Dmitry Zamaruev
<address@hidden> wrote:
> Hi!
> Latest qemu release introduced support for Q35 chipset officially.
> Is there someone who was able to boot it ?
> Following instruction in ChangeLog
> (http://wiki.qemu.org/ChangeLog/1.3#x86) I used most recent SeaBIOS
> version.
> Used software versions:
> ~/work/qemu $ git describe --tags
> v1.3.0
> ~/work/seabios $ git describe --tags
> rel-1.7.1-85-g57174c7
> SeaBIOS compiled with default configuration (CONFIG_AHCI=y), qemu
> compiled with following configuration:
> ./configure --target-list=i386-softmmu --enable-debug
> I tried to run qemu using following command line:
> ./i386-softmmu/qemu-system-i386 -curses -M q35 -L ./pc-bios/ -bios
> ../seabios/out/bios.bin -acpitable
> file=../seabios/out/q35-acpi-dsdt.aml -hda
> ~/linux-microcore-4.0.2-clean.img
> And it fails to boot from hard drive, SeaBIOS output:
> Booting from Hard Disk...
> Boot failed: could not read the boot disk
> Is there any tested SeaBIOS revision that could be used to boot new
> q35 chipset ?
> wbr,
> Dmitry.

I was able to start qemu with another (new?) syntax:
qemu-system-i386 -M q35 -drive
But shouldn't -hda be an "alias" to this (with -M pc-1.3 it seems an
alias to if=ide,bus=0)

reply via email to

[Prev in Thread] Current Thread [Next in Thread]