[PULL 09/28] trans_privileged.c.inc: set (m|s)tval on ebreak breakpoint

[Alistair Francis]

From: Daniel Henrique Barboza <dbarboza@ventanamicro.com>

Privileged spec section 4.1.9 mentions:

"When a trap is taken into S-mode, stval is written with
exception-specific information to assist software in handling the trap.
(...)

If stval is written with a nonzero value when a breakpoint,
address-misaligned, access-fault, or page-fault exception occurs on an
instruction fetch, load, or store, then stval will contain the faulting
virtual address."

A similar text is found for mtval in section 3.1.16.

Setting mtval/stval in this scenario is optional, but some softwares read
these regs when handling ebreaks.

Write 'badaddr' in all ebreak breakpoints to write the appropriate
'tval' during riscv_do_cpu_interrrupt().

Signed-off-by: Daniel Henrique Barboza <dbarboza@ventanamicro.com>
Reviewed-by: Alistair Francis <alistair.francis@wdc.com>
Reviewed-by: LIU Zhiwei <zhiwei_liu@linux.alibaba.com>
Reviewed-by: Richard Henderson <richard.henderson@linaro.org>
Message-ID: <20240416230437.1869024-3-dbarboza@ventanamicro.com>
Signed-off-by: Alistair Francis <alistair.francis@wdc.com>
---
 target/riscv/insn_trans/trans_privileged.c.inc | 2 ++
 1 file changed, 2 insertions(+)

diff --git a/target/riscv/insn_trans/trans_privileged.c.inc 
b/target/riscv/insn_trans/trans_privileged.c.inc
index 620ab54eb0..bc5263a4e0 100644
--- a/target/riscv/insn_trans/trans_privileged.c.inc
+++ b/target/riscv/insn_trans/trans_privileged.c.inc
@@ -62,6 +62,8 @@ static bool trans_ebreak(DisasContext *ctx, arg_ebreak *a)
     if (pre == 0x01f01013 && ebreak == 0x00100073 && post == 0x40705013) {
         generate_exception(ctx, RISCV_EXCP_SEMIHOST);
     } else {
+        tcg_gen_st_tl(tcg_constant_tl(ebreak_addr), tcg_env,
+                      offsetof(CPURISCVState, badaddr));
         generate_exception(ctx, RISCV_EXCP_BREAKPOINT);
     }
     return true;
-- 
2.45.1