[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[RFC v1 1/2] hw/arm/virt-acpi-build.c: Migrate SPCR creation to common l
From: |
Sia Jee Heng |
Subject: |
[RFC v1 1/2] hw/arm/virt-acpi-build.c: Migrate SPCR creation to common location |
Date: |
Thu, 28 Dec 2023 16:06:15 +0800 |
RISC-V should also generate the SPCR in a manner similar to ARM.
Therefore, instead of replicating the code, relocate this function
to the common AML build.
Signed-off-by: Sia Jee Heng <jeeheng.sia@starfivetech.com>
---
hw/acpi/aml-build.c | 51 ++++++++++++++++++++++++++++
hw/arm/virt-acpi-build.c | 68 +++++++++++++++----------------------
include/hw/acpi/acpi-defs.h | 33 ++++++++++++++++++
include/hw/acpi/aml-build.h | 4 +++
4 files changed, 115 insertions(+), 41 deletions(-)
diff --git a/hw/acpi/aml-build.c b/hw/acpi/aml-build.c
index af66bde0f5..1efa534aa8 100644
--- a/hw/acpi/aml-build.c
+++ b/hw/acpi/aml-build.c
@@ -1994,6 +1994,57 @@ static void build_processor_hierarchy_node(GArray *tbl,
uint32_t flags,
}
}
+void build_spcr(GArray *table_data, BIOSLinker *linker,
+ const AcpiSpcrData *f, const char *oem_id,
+ const char *oem_table_id)
+{
+ AcpiTable table = { .sig = "SPCR", .rev = 2, .oem_id = oem_id,
+ .oem_table_id = oem_table_id };
+
+ acpi_table_begin(&table, table_data);
+ /* Interface type */
+ build_append_int_noprefix(table_data, f->interface_type, 1);
+ /* Reserved */
+ build_append_int_noprefix(table_data, 0, 3);
+ /* Base Address */
+ build_append_gas(table_data, f->base_addr.id, f->base_addr.width,
+ f->base_addr.offset, f->base_addr.size,
+ f->base_addr.addr);
+ /* Interrupt type */
+ build_append_int_noprefix(table_data, f->interrupt_type, 1);
+ /* IRQ */
+ build_append_int_noprefix(table_data, f->pc_interrupt, 1);
+ /* Global System Interrupt */
+ build_append_int_noprefix(table_data, f->interrupt, 4);
+ /* Baud Rate */
+ build_append_int_noprefix(table_data, f->baud_rate, 1);
+ /* Parity */
+ build_append_int_noprefix(table_data, f->parity, 1);
+ /* Stop Bits */
+ build_append_int_noprefix(table_data, f->stop_bits, 1);
+ /* Flow Control */
+ build_append_int_noprefix(table_data, f->flow_control, 1);
+ /* Terminal Type */
+ build_append_int_noprefix(table_data, f->terminal_type, 1);
+ /* PCI Device ID */
+ build_append_int_noprefix(table_data, f->pci_device_id, 2);
+ /* PCI Vendor ID */
+ build_append_int_noprefix(table_data, f->pci_vendor_id, 2);
+ /* PCI Bus Number */
+ build_append_int_noprefix(table_data, f->pci_bus, 1);
+ /* PCI Device Number */
+ build_append_int_noprefix(table_data, f->pci_device, 1);
+ /* PCI Function Number */
+ build_append_int_noprefix(table_data, f->pci_function, 1);
+ /* PCI Flags */
+ build_append_int_noprefix(table_data, f->pci_flags, 4);
+ /* PCI Segment */
+ build_append_int_noprefix(table_data, f->pci_segment, 1);
+ /* Reserved */
+ build_append_int_noprefix(table_data, 0, 4);
+
+ acpi_table_end(linker, &table);
+}
/*
* ACPI spec, Revision 6.3
* 5.2.29 Processor Properties Topology Table (PPTT)
diff --git a/hw/arm/virt-acpi-build.c b/hw/arm/virt-acpi-build.c
index 510ab0dcca..a31f736d1a 100644
--- a/hw/arm/virt-acpi-build.c
+++ b/hw/arm/virt-acpi-build.c
@@ -431,48 +431,34 @@ build_iort(GArray *table_data, BIOSLinker *linker,
VirtMachineState *vms)
* Rev: 1.07
*/
static void
-build_spcr(GArray *table_data, BIOSLinker *linker, VirtMachineState *vms)
+build_spcr_v2(GArray *table_data, BIOSLinker *linker, VirtMachineState *vms)
{
- AcpiTable table = { .sig = "SPCR", .rev = 2, .oem_id = vms->oem_id,
- .oem_table_id = vms->oem_table_id };
-
- acpi_table_begin(&table, table_data);
-
- /* Interface Type */
- build_append_int_noprefix(table_data, 3, 1); /* ARM PL011 UART */
- build_append_int_noprefix(table_data, 0, 3); /* Reserved */
- /* Base Address */
- build_append_gas(table_data, AML_AS_SYSTEM_MEMORY, 32, 0, 3,
- vms->memmap[VIRT_UART].base);
- /* Interrupt Type */
- build_append_int_noprefix(table_data,
- (1 << 3) /* Bit[3] ARMH GIC interrupt */, 1);
- build_append_int_noprefix(table_data, 0, 1); /* IRQ */
- /* Global System Interrupt */
- build_append_int_noprefix(table_data,
- vms->irqmap[VIRT_UART] + ARM_SPI_BASE, 4);
- build_append_int_noprefix(table_data, 3 /* 9600 */, 1); /* Baud Rate */
- build_append_int_noprefix(table_data, 0 /* No Parity */, 1); /* Parity */
- /* Stop Bits */
- build_append_int_noprefix(table_data, 1 /* 1 Stop bit */, 1);
- /* Flow Control */
- build_append_int_noprefix(table_data,
- (1 << 1) /* RTS/CTS hardware flow control */, 1);
- /* Terminal Type */
- build_append_int_noprefix(table_data, 0 /* VT100 */, 1);
- build_append_int_noprefix(table_data, 0, 1); /* Language */
- /* PCI Device ID */
- build_append_int_noprefix(table_data, 0xffff /* not a PCI device*/, 2);
- /* PCI Vendor ID */
- build_append_int_noprefix(table_data, 0xffff /* not a PCI device*/, 2);
- build_append_int_noprefix(table_data, 0, 1); /* PCI Bus Number */
- build_append_int_noprefix(table_data, 0, 1); /* PCI Device Number */
- build_append_int_noprefix(table_data, 0, 1); /* PCI Function Number */
- build_append_int_noprefix(table_data, 0, 4); /* PCI Flags */
- build_append_int_noprefix(table_data, 0, 1); /* PCI Segment */
- build_append_int_noprefix(table_data, 0, 4); /* Reserved */
+ AcpiSpcrData serial = {
+ .interface_type = 3, /* ARM PL011 UART */
+ .base_addr.id = AML_AS_SYSTEM_MEMORY,
+ .base_addr.width = 32,
+ .base_addr.offset = 0,
+ .base_addr.size = 3,
+ .base_addr.addr = vms->memmap[VIRT_UART].base,
+ .interrupt_type = (1 << 3),/* Bit[3] ARMH GIC interrupt*/
+ .pc_interrupt = 0, /* IRQ */
+ .interrupt = (vms->irqmap[VIRT_UART] + ARM_SPI_BASE),
+ .baud_rate = 3, /* 9600 */
+ .parity = 0, /* No Parity */
+ .stop_bits = 1, /* 1 Stop bit */
+ .flow_control = 1 << 1, /* RTS/CTS hardware flow control */
+ .terminal_type = 0, /* VT100 */
+ .language = 0, /* Language */
+ .pci_device_id = 0xffff, /* not a PCI device*/
+ .pci_vendor_id = 0xffff, /* not a PCI device*/
+ .pci_bus = 0,
+ .pci_device = 0,
+ .pci_function = 0,
+ .pci_flags = 0,
+ .pci_segment = 0,
+ };
- acpi_table_end(linker, &table);
+ build_spcr(table_data, linker, &serial, vms->oem_id, vms->oem_table_id);
}
/*
@@ -930,7 +916,7 @@ void virt_acpi_build(VirtMachineState *vms, AcpiBuildTables
*tables)
}
acpi_add_table(table_offsets, tables_blob);
- build_spcr(tables_blob, tables->linker, vms);
+ build_spcr_v2(tables_blob, tables->linker, vms);
acpi_add_table(table_offsets, tables_blob);
build_dbg2(tables_blob, tables->linker, vms);
diff --git a/include/hw/acpi/acpi-defs.h b/include/hw/acpi/acpi-defs.h
index 2b42e4192b..0e6e82b339 100644
--- a/include/hw/acpi/acpi-defs.h
+++ b/include/hw/acpi/acpi-defs.h
@@ -90,6 +90,39 @@ typedef struct AcpiFadtData {
unsigned *xdsdt_tbl_offset;
} AcpiFadtData;
+typedef struct AcpiGas {
+ uint8_t id; /* Address space ID */
+ uint8_t width; /* Register bit width */
+ uint8_t offset; /* Register bit offset */
+ uint8_t size; /* Access size */
+ uint64_t addr; /* Address */
+} AcpiGas;
+
+/* SPCR (Serial Port Console Redirection table) */
+typedef struct AcpiSpcrData {
+ uint8_t interface_type;
+ uint8_t reserved[3];
+ struct AcpiGas base_addr;
+ uint8_t interrupt_type;
+ uint8_t pc_interrupt;
+ uint32_t interrupt; /* Global system interrupt */
+ uint8_t baud_rate;
+ uint8_t parity;
+ uint8_t stop_bits;
+ uint8_t flow_control;
+ uint8_t terminal_type;
+ uint8_t language;
+ uint8_t reserved1;
+ uint16_t pci_device_id; /* Must be 0xffff if not PCI device */
+ uint16_t pci_vendor_id; /* Must be 0xffff if not PCI device */
+ uint8_t pci_bus;
+ uint8_t pci_device;
+ uint8_t pci_function;
+ uint32_t pci_flags;
+ uint8_t pci_segment;
+ uint32_t reserved2;
+} AcpiSpcrData;
+
#define ACPI_FADT_ARM_PSCI_COMPLIANT (1 << 0)
#define ACPI_FADT_ARM_PSCI_USE_HVC (1 << 1)
diff --git a/include/hw/acpi/aml-build.h b/include/hw/acpi/aml-build.h
index ff2a310270..44e03e76bd 100644
--- a/include/hw/acpi/aml-build.h
+++ b/include/hw/acpi/aml-build.h
@@ -497,4 +497,8 @@ void build_fadt(GArray *tbl, BIOSLinker *linker, const
AcpiFadtData *f,
void build_tpm2(GArray *table_data, BIOSLinker *linker, GArray *tcpalog,
const char *oem_id, const char *oem_table_id);
+
+void build_spcr(GArray *table_data, BIOSLinker *linker,
+ const AcpiSpcrData *f, const char *oem_id,
+ const char *oem_table_id);
#endif
--
2.34.1