[PATCH] shpc: disallow unplug when power indicator is blinking

[Vladimir Sementsov-Ogievskiy]

Pressing attention button has special meaning when power indicator is
blinking. Better just not do it.

For example, trying to remove device immediately after hotplug leads to
both commands succeded but device not actually unrealized.

Same thing for PCIE hotplug was done in
  81124b3c7a5dae "pcie: add power indicator blink check"

Signed-off-by: Vladimir Sementsov-Ogievskiy <vsementsov@yandex-team.ru>
---
 hw/pci/shpc.c | 7 +++++++
 1 file changed, 7 insertions(+)

diff --git a/hw/pci/shpc.c b/hw/pci/shpc.c
index e71f3a7483..fca7f6691a 100644
--- a/hw/pci/shpc.c
+++ b/hw/pci/shpc.c
@@ -568,6 +568,13 @@ void shpc_device_unplug_request_cb(HotplugHandler 
*hotplug_dev,
 
     state = shpc_get_status(shpc, slot, SHPC_SLOT_STATE_MASK);
     led = shpc_get_status(shpc, slot, SHPC_SLOT_PWR_LED_MASK);
+
+    if (led == SHPC_LED_BLINK) {
+        error_setg(errp, "Hot-unplug failed: "
+                   "guest is busy (power indicator blinking)");
+        return;
+    }
+
     if (state == SHPC_STATE_DISABLED && led == SHPC_LED_OFF) {
         shpc_free_devices_in_slot(shpc, slot);
         shpc_set_status(shpc, slot, 1, SHPC_SLOT_STATUS_MRL_OPEN);
-- 
2.34.1