[PULL 04/12] tests/qtest/libqos/e1000e: Use E1000_STATUS_ASDV_1000

[Thomas Huth]

From: Akihiko Odaki <akihiko.odaki@daynix.com>

Nemonics E1000_STATUS_LAN_INIT_DONE and E1000_STATUS_ASDV_1000 have
the same value, and E1000_STATUS_ASDV_1000 should be used here because
E1000_STATUS_ASDV_1000 represents the auto-detected speed tested here
while E1000_STATUS_LAN_INIT_DONE is a value used for a different purpose
with a variant of e1000e family different from the one implemented in
QEMU.

Signed-off-by: Akihiko Odaki <akihiko.odaki@daynix.com>
Message-Id: <20221103083425.100590-1-akihiko.odaki@daynix.com>
Reviewed-by: Philippe Mathieu-Daudé <philmd@linaro.org>
Signed-off-by: Thomas Huth <thuth@redhat.com>
---
 tests/qtest/libqos/e1000e.c | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/tests/qtest/libqos/e1000e.c b/tests/qtest/libqos/e1000e.c
index 4fd0bd5311..05af6f2118 100644
--- a/tests/qtest/libqos/e1000e.c
+++ b/tests/qtest/libqos/e1000e.c
@@ -130,8 +130,8 @@ static void e1000e_pci_start_hw(QOSGraphObject *obj)
 
     /* Check the device status - link and speed */
     val = e1000e_macreg_read(&d->e1000e, E1000_STATUS);
-    g_assert_cmphex(val & (E1000_STATUS_LU | E1000_STATUS_LAN_INIT_DONE),
-        ==, E1000_STATUS_LU | E1000_STATUS_LAN_INIT_DONE);
+    g_assert_cmphex(val & (E1000_STATUS_LU | E1000_STATUS_ASDV_1000),
+        ==, E1000_STATUS_LU | E1000_STATUS_ASDV_1000);
 
     /* Initialize TX/RX logic */
     e1000e_macreg_write(&d->e1000e, E1000_RCTL, 0);
-- 
2.31.1