[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[PATCH] tests/qtest/libqos/e1000e: Use E1000_STATUS_ASDV_1000
From: |
Akihiko Odaki |
Subject: |
[PATCH] tests/qtest/libqos/e1000e: Use E1000_STATUS_ASDV_1000 |
Date: |
Thu, 3 Nov 2022 17:34:25 +0900 |
Nemonics E1000_STATUS_LAN_INIT_DONE and E1000_STATUS_ASDV_1000 have
the same value, and E1000_STATUS_ASDV_1000 should be used here because
E1000_STATUS_ASDV_1000 represents the auto-detected speed tested here
while E1000_STATUS_LAN_INIT_DONE is a value used for a different purpose
with a variant of e1000e family different from the one implemented in
QEMU.
Signed-off-by: Akihiko Odaki <akihiko.odaki@daynix.com>
---
tests/qtest/libqos/e1000e.c | 4 ++--
1 file changed, 2 insertions(+), 2 deletions(-)
diff --git a/tests/qtest/libqos/e1000e.c b/tests/qtest/libqos/e1000e.c
index 11d9f55c66..178d61d04f 100644
--- a/tests/qtest/libqos/e1000e.c
+++ b/tests/qtest/libqos/e1000e.c
@@ -130,8 +130,8 @@ static void e1000e_pci_start_hw(QOSGraphObject *obj)
/* Check the device status - link and speed */
val = e1000e_macreg_read(&d->e1000e, E1000_STATUS);
- g_assert_cmphex(val & (E1000_STATUS_LU | E1000_STATUS_LAN_INIT_DONE),
- ==, E1000_STATUS_LU | E1000_STATUS_LAN_INIT_DONE);
+ g_assert_cmphex(val & (E1000_STATUS_LU | E1000_STATUS_ASDV_1000),
+ ==, E1000_STATUS_LU | E1000_STATUS_ASDV_1000);
/* Initialize TX/RX logic */
e1000e_macreg_write(&d->e1000e, E1000_RCTL, 0);
--
2.38.1
- [PATCH] tests/qtest/libqos/e1000e: Use E1000_STATUS_ASDV_1000,
Akihiko Odaki <=