[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [PATCH v4] failover: unregister ROM on unplug
From: |
Laurent Vivier |
Subject: |
Re: [PATCH v4] failover: unregister ROM on unplug |
Date: |
Fri, 23 Jul 2021 10:55:29 +0200 |
User-agent: |
Mozilla/5.0 (X11; Linux x86_64; rv:78.0) Gecko/20100101 Thunderbird/78.11.0 |
On 21/07/2021 18:19, Michael S. Tsirkin wrote:
> On Wed, Jul 21, 2021 at 06:09:05PM +0200, Laurent Vivier wrote:
>> The intend of failover is to allow to migrate a VM with a VFIO
>> networking card without disrupting the network operation by switching
>> to a virtio-net device during the migration.
>>
>> This simple change allows to test failover with a simulated device
>> like e1000e rather than a vfio device, even if it's useless in real
>> life it can help to debug failover.
>>
>> This is interesting to developers that want to test failover on
>> a system with no vfio device. Moreover it simplifies host networking
>> configuration as we can use the same bridge for virtio-net and
>> the other failover networking device.
>>
>> Without this change the migration of a system configured with failover
>> fails with:
>>
>> ...
>> -device virtio-net-pci,id=virtionet0,failover=on,... \
>> -device e1000,failover_pair_id=virtionet0,... \
>> ...
>>
>> (qemu) migrate ...
>>
>> Unknown ramblock "0000:00:01.1:00.0/e1000e.rom", cannot accept migration
>> error while loading state for instance 0x0 of device 'ram'
>> load of migration failed: Invalid argument
>>
>> This happens because QEMU correctly unregisters the interface vmstate but
>> not the ROM one. This patch fixes that.
>>
>> Signed-off-by: Laurent Vivier <lvivier@redhat.com>
>
> And does failover_replug_primary roll it all back then?
In fact, I think we cannot roll it back because we don't have all the
information to do
the vmstate_register() again. Perhaps we can implement a
vmstate_disable()/vmstate_enable() to disable the state migration without
removing the
information from the list?
Thanks,
Laurent