[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[PATCH 2/2] docs/system: ppc: Update ppce500 documentation with eTSEC su
From: |
Bin Meng |
Subject: |
[PATCH 2/2] docs/system: ppc: Update ppce500 documentation with eTSEC support |
Date: |
Tue, 6 Jul 2021 12:31:24 +0800 |
This adds eTSEC support to the PowerPC `ppce500` machine documentation.
Signed-off-by: Bin Meng <bmeng.cn@gmail.com>
---
docs/system/ppc/ppce500.rst | 10 +++++++++-
1 file changed, 9 insertions(+), 1 deletion(-)
diff --git a/docs/system/ppc/ppce500.rst b/docs/system/ppc/ppce500.rst
index 7a815c1881..afc58f60f5 100644
--- a/docs/system/ppc/ppce500.rst
+++ b/docs/system/ppc/ppce500.rst
@@ -19,6 +19,7 @@ The ``ppce500`` machine supports the following devices:
* Power-off functionality via one GPIO pin
* 1 Freescale MPC8xxx PCI host controller
* VirtIO devices via PCI bus
+* 1 Freescale Enhanced Triple Speed Ethernet controller (eTSEC)
Hardware configuration information
----------------------------------
@@ -121,7 +122,7 @@ To boot the 32-bit Linux kernel:
Running U-Boot
--------------
-U-Boot mainline v2021.04 release is tested at the time of writing. To build a
+U-Boot mainline v2021.07 release is tested at the time of writing. To build a
U-Boot mainline bootloader that can be booted by the ``ppce500`` machine, use
the qemu-ppce500_defconfig with similar commands as described above for Linux:
@@ -154,3 +155,10 @@ interface at PCI address 0.1.0, but we can switch that to
an e1000 NIC by:
-display none -serial stdio \
-bios u-boot \
-nic tap,ifname=tap0,script=no,downscript=no,model=e1000
+
+The QEMU ``ppce500`` machine can also dynamically instantiate an eTSEC device
+if “-device eTSEC” is given to QEMU:
+
+.. code-block:: bash
+
+ -netdev tap,ifname=tap0,script=no,downscript=no,id=net0 -device
eTSEC,netdev=net0
--
2.25.1