[PATCH v2 1/1] linux-user/signal: Decode waitid si_code

[Alistair Francis]

When mapping the host waitid status to the target status we previously
just used decoding information in the status value. This doesn't follow
what the waitid documentation describes, which instead suggests using
the si_code value for the decoding. This results in the incorrect values
seen when calling waitid. This is especially apparent on RV32 where all
wait calls use waitid (see the bug case).

This patch just passes the waitid status directly back to the guest.

Buglink: https://bugs.launchpad.net/qemu/+bug/1906193
Signed-off-by: Alistair Francis <alistair.francis@wdc.com>
---
v2:
 - Set tinfo->_sifields._sigchld._status directly from status

 linux-user/signal.c | 3 +--
 1 file changed, 1 insertion(+), 2 deletions(-)

diff --git a/linux-user/signal.c b/linux-user/signal.c
index 73de934c65..7eecec46c4 100644
--- a/linux-user/signal.c
+++ b/linux-user/signal.c
@@ -349,8 +349,7 @@ static inline void 
host_to_target_siginfo_noswap(target_siginfo_t *tinfo,
         case TARGET_SIGCHLD:
             tinfo->_sifields._sigchld._pid = info->si_pid;
             tinfo->_sifields._sigchld._uid = info->si_uid;
-            tinfo->_sifields._sigchld._status
-                = host_to_target_waitstatus(info->si_status);
+            tinfo->_sifields._sigchld._status = info->si_status;
             tinfo->_sifields._sigchld._utime = info->si_utime;
             tinfo->_sifields._sigchld._stime = info->si_stime;
             si_type = QEMU_SI_CHLD;
-- 
2.29.2