Re: does make check now require TCG? Or is it a parallelism issue?

[Paolo Bonzini]

On 09/10/20 09:21, Thomas Huth wrote:
> On 08/10/2020 20.24, Paolo Bonzini wrote:
>>
>>
>> Il gio 8 ott 2020, 20:05 Richard Henderson <richard.henderson@linaro.org
>> <mailto:richard.henderson@linaro.org>> ha scritto:
>>
>>     Ah, TARGET_DIRS isn't being pruned anymore when a target is disabled for
>>     lack
>>     of accelerator.
>>
>>     Paolo, side effect of 8a19980e3f ("configure: move accelerator logic to
>>     meson")?  I guess we should move the setting of TARGET_DIRS to meson as
>>     well.
>>
>>
>> TARGET_DIRS is pruned by Meson, I didn't add any back propagation to make
>> because it is not really needed; qemu-iotests only every uses the "host
>> architecture" QEMU binary (see tests/qemu-iotests/common.config),
>> check-block + --target-list has never worked.
> 
> I haven't tried since the meson conversion, but at least a couple of months
> ago, it was perfectly fine to run configure with
> --target-list=tricore-softmmu and then to run "make check-block" afterwards.

Thanks, I didn't know.  Actually it's possible to get the targets from
Makefile.ninja.  I'll send a patch.

Paolo