[PATCH for-5.1] xhci: fix valid.max_access_size to access address registers

[Laurent Vivier]

QEMU XHCI advertises AC64 (64-bit addressing) but doesn't allow
64-bit mode access in "runtime" and "operational" MemoryRegionOps.

Set the max_access_size based on sizeof(dma_addr_t) as AC64 is set.

XHCI specs:
"If the xHC supports 64-bit addressing (AC64 = ‘1’), then software
should write 64-bit registers using only Qword accesses.  If a
system is incapable of issuing Qword accesses, then writes to the
64-bit address fields shall be performed using 2 Dword accesses;
low Dword-first, high-Dword second.  If the xHC supports 32-bit
addressing (AC64 = ‘0’), then the high Dword of registers containing
64-bit address fields are unused and software should write addresses
using only Dword accesses"

The problem has been detected with SLOF, as linux kernel always accesses
registers using 32-bit access even if AC64 is set and revealed by
5d971f9e6725 ("memory: Revert "memory: accept mismatching sizes in 
memory_region_access_valid"")

Suggested-by: Alexey Kardashevskiy <aik@au1.ibm.com>
Signed-off-by: Laurent Vivier <lvivier@redhat.com>
---
 hw/usb/hcd-xhci.c | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/hw/usb/hcd-xhci.c b/hw/usb/hcd-xhci.c
index b330e36fe6cc..67a18fe2b64c 100644
--- a/hw/usb/hcd-xhci.c
+++ b/hw/usb/hcd-xhci.c
@@ -3184,7 +3184,7 @@ static const MemoryRegionOps xhci_oper_ops = {
     .read = xhci_oper_read,
     .write = xhci_oper_write,
     .valid.min_access_size = 4,
-    .valid.max_access_size = 4,
+    .valid.max_access_size = sizeof(dma_addr_t),
     .endianness = DEVICE_LITTLE_ENDIAN,
 };
 
@@ -3200,7 +3200,7 @@ static const MemoryRegionOps xhci_runtime_ops = {
     .read = xhci_runtime_read,
     .write = xhci_runtime_write,
     .valid.min_access_size = 4,
-    .valid.max_access_size = 4,
+    .valid.max_access_size = sizeof(dma_addr_t),
     .endianness = DEVICE_LITTLE_ENDIAN,
 };
 
-- 
2.26.2