qemu-devel
[Top][All Lists]
Advanced

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [PATCH 09/10] arm: allwinner-h3: add SD/MMC host controller


From: Niek Linnenbank
Subject: Re: [PATCH 09/10] arm: allwinner-h3: add SD/MMC host controller
Date: Sat, 14 Dec 2019 21:32:11 +0100



On Sat, Dec 14, 2019 at 2:59 PM Philippe Mathieu-Daudé <address@hidden> wrote:
On 12/13/19 10:00 PM, Niek Linnenbank wrote:
> On Fri, Dec 13, 2019 at 12:56 AM Philippe Mathieu-Daudé
> <address@hidden <mailto:address@hidden>> wrote:
>
>     Hi Niek,
>
>     On 12/11/19 11:34 PM, Niek Linnenbank wrote:
>      > Ping!
>      >
>      > Anyone would like to comment on this driver?
>      >
>      > I finished the rework on all previous comments in this series.
>      >
>      > Currently debugging the hflags error reported by Philippe.
>      > After that, I'm ready to send out v2 of these patches.
>      >
>      > Regards,
>      > Niek
>      >
>      > On Mon, Dec 2, 2019 at 10:10 PM Niek Linnenbank
>      > <address@hidden <mailto:address@hidden>
>     <mailto:address@hidden <mailto:address@hidden>>>
>     wrote:
>      >
>      >     The Allwinner H3 System on Chip contains an integrated storage
>      >     controller for Secure Digital (SD) and Multi Media Card (MMC)
>      >     interfaces. This commit adds support for the Allwinner H3
>      >     SD/MMC storage controller with the following emulated features:
>      >
>      >       * DMA transfers
>      >       * Direct FIFO I/O
>      >       * Short/Long format command responses
>      >       * Auto-Stop command (CMD12)
>      >       * Insert & remove card detection
>      >
>      >     Signed-off-by: Niek Linnenbank <address@hidden
>     <mailto:address@hidden>
>      >     <mailto:address@hidden
>     <mailto:address@hidden>>>
>      >     ---
>      >       hw/arm/allwinner-h3.c               |  20 +
>      >       hw/arm/orangepi.c                   |  17 +
>      >       hw/sd/Makefile.objs                 |   1 +
>      >       hw/sd/allwinner-h3-sdhost.c         | 791
>     ++++++++++++++++++++++++++++
>      >       hw/sd/trace-events                  |   7 +
>      >       include/hw/arm/allwinner-h3.h       |   2 +
>      >       include/hw/sd/allwinner-h3-sdhost.h |  73 +++
>      >       7 files changed, 911 insertions(+)
>      >       create mode 100644 hw/sd/allwinner-h3-sdhost.c
>      >       create mode 100644 include/hw/sd/allwinner-h3-sdhost.h
[...]
> Thanks again for all of your helpful comments Philippe!
> I've started to rework the patch.
>
> One question about adding tags in the commit message: should I
> already add 'Reviewed-by: ' when I re-send v2 of this patch? Or should
> that be added after you have seen the v2 changes?

You shouldn't add the Reviewed-by tag until explicitly given by the
reviewer. If the changes are trivial, it is easy to conditionally give
the tag such "If ... is done: R-b", "With ... fixed: R-b".

OK, thanks for clarifying, I'll keep that in mind.
 

Since this is your first contribution, I have been more careful. Also
since your patch is already of very good quality, I'v been a bit picky
regarding few details.
 
Sure, that makes sense indeed. And I very much appreciate your feedback Philippe,
so please keep doing that, even about the small details ;-)
 

Since there are too many comments, so I prefer to fully review the v2 of
this patch again.

Yes, true indeed.

Regards,
Niek
 
Regards,

Phil.



--
Niek Linnenbank


reply via email to

[Prev in Thread] Current Thread [Next in Thread]