Re: [Qemu-devel] [PATCH 2/2] dma/rc4030: Minor code style cleanup

[Philippe Mathieu-Daudé]

On 6/25/19 4:27 PM, Aleksandar Markovic wrote:
> From: Aleksandar Markovic <address@hidden>
> 
> Fix some simple checkpatch.pl warnings in rc4030.c.
> 
> Signed-off-by: Aleksandar Markovic <address@hidden>

Reviewed-by: Philippe Mathieu-Daudé <address@hidden>

> ---
>  hw/dma/rc4030.c | 18 +++++++++++-------
>  1 file changed, 11 insertions(+), 7 deletions(-)
> 
> diff --git a/hw/dma/rc4030.c b/hw/dma/rc4030.c
> index 88ff271..155af9b 100644
> --- a/hw/dma/rc4030.c
> +++ b/hw/dma/rc4030.c
> @@ -58,8 +58,8 @@ typedef struct dma_pagetable_entry {
>  
>  #define TYPE_RC4030_IOMMU_MEMORY_REGION "rc4030-iommu-memory-region"
>  
> -typedef struct rc4030State
> -{
> +typedef struct rc4030State {
> +
>      SysBusDevice parent;
>  
>      uint32_t config; /* 0x0000: RC4030 config register */
> @@ -152,8 +152,9 @@ static uint64_t rc4030_read(void *opaque, hwaddr addr, 
> unsigned int size)
>      case 0x0058:
>          val = s->cache_bmask;
>          /* HACK */
> -        if (s->cache_bmask == (uint32_t)-1)
> +        if (s->cache_bmask == (uint32_t)-1) {
>              s->cache_bmask = 0;
> +        }
>          break;
>      /* Remote Speed Registers */
>      case 0x0070:
> @@ -538,8 +539,9 @@ static void rc4030_reset(DeviceState *dev)
>  
>      s->memory_refresh_rate = 0x18186;
>      s->nvram_protect = 7;
> -    for (i = 0; i < 15; i++)
> +    for (i = 0; i < 15; i++) {
>          s->rem_speed[i] = 7;
> +    }
>      s->imr_jazz = 0x10; /* XXX: required by firmware, but why? */
>      s->isr_jazz = 0;
>  
> @@ -551,7 +553,7 @@ static void rc4030_reset(DeviceState *dev)
>  
>  static int rc4030_post_load(void *opaque, int version_id)
>  {
> -    rc4030State* s = opaque;
> +    rc4030State *s = opaque;
>  
>      set_next_tick(s);
>      update_jazz_irq(s);
> @@ -591,7 +593,8 @@ static void rc4030_do_dma(void *opaque, int n, uint8_t 
> *buf, int len, int is_wri
>      hwaddr dma_addr;
>      int dev_to_mem;
>  
> -    s->dma_regs[n][DMA_REG_ENABLE] &= ~(DMA_FLAG_TC_INTR | DMA_FLAG_MEM_INTR 
> | DMA_FLAG_ADDR_INTR);
> +    s->dma_regs[n][DMA_REG_ENABLE] &=
> +           ~(DMA_FLAG_TC_INTR | DMA_FLAG_MEM_INTR | DMA_FLAG_ADDR_INTR);
>  
>      /* Check DMA channel consistency */
>      dev_to_mem = (s->dma_regs[n][DMA_REG_ENABLE] & DMA_FLAG_MEM_TO_DEV) ? 0 
> : 1;
> @@ -603,8 +606,9 @@ static void rc4030_do_dma(void *opaque, int n, uint8_t 
> *buf, int len, int is_wri
>      }
>  
>      /* Get start address and len */
> -    if (len > s->dma_regs[n][DMA_REG_COUNT])
> +    if (len > s->dma_regs[n][DMA_REG_COUNT]) {
>          len = s->dma_regs[n][DMA_REG_COUNT];
> +    }
>      dma_addr = s->dma_regs[n][DMA_REG_ADDRESS];
>  
>      /* Read/write data at right place */
>