Re: [Qemu-devel] [PATCH] configure: Relax check for libseccomp

[Daniel P . Berrangé]

On Wed, Apr 03, 2019 at 02:49:48PM +0200, Helge Deller wrote:
> On a non-release architecture, the configure program aborts if the
> --enable-seccomp flag was given (with no way to work around it on the
> command line):
> 
> ERROR: User requested feature libseccomp
>       configure was not able to find it.
>       libseccomp is not supported for host cpu parisc64
> 
> Instead of aborting, fall back to require libseccomp version 2.2.0
> (or any higher version currently installed) which should be OK for
> non-release architectures.
> 
> Signed-off-by: Helge Deller <address@hidden>
> 
> diff --git a/configure b/configure
> index 1c563a7027..8632267049 100755
> --- a/configure
> +++ b/configure
> @@ -2389,7 +2389,6 @@ if test "$seccomp" != "no" ; then
>          libseccomp_minver="2.3.0"
>          ;;
>      *)
> -        libseccomp_minver=""
>          ;;
>      esac

This makes sense to me. From a QEMU source POV we are able to build with
libseccomp >= 2.2.0, which our default libseccomp_minver= env expresses
a few lines earlier.

If libseccomp isn't supported on a platform, then I think we should just
assume that libseccomp won't be present in the OS install we are building
against. I don't think QEMU needs to second-guess whether or not it is
supported on the given architecture. In fact I'd go as far as to say we
could probably just remove all this per-arch checking and just have a
generic >= 2.2.0 check, and just rely on fact libseccomp won't exist
on a s390/ppc/etc host if the distro had version < 2.3.0

Anyway, this particular patch is better than what we have so on that
basis I think we can just apply this as-is:

  Reviewed-by: Daniel P. Berrangé <address@hidden>


Regards,
Daniel
-- 
|: https://berrange.com      -o-    https://www.flickr.com/photos/dberrange :|
|: https://libvirt.org         -o-            https://fstop138.berrange.com :|
|: https://entangle-photo.org    -o-    https://www.instagram.com/dberrange :|