qemu-devel
[Top][All Lists]
Advanced

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[Qemu-devel] megasas: Unexpected response from lun 1 while scanning, sca


From: Dongli Zhang
Subject: [Qemu-devel] megasas: Unexpected response from lun 1 while scanning, scan aborted
Date: Tue, 26 Mar 2019 09:47:50 -0700 (PDT)

I am reporting an error that the scsi lun cannot initialize successfully when I
am emulating megasas scsi controller with qemu.

I am not sure if this is issue in qemu or linux kernel.

When 'lun=1' is specified, there is "Unexpected response from lun 1 while
scanning, scan aborted".

Everything works well if 'lun=0' is specified.


Below is the qemu cmdline involved:

-device megasas,id=scsi0 \
-device scsi-hd,drive=drive0,bus=scsi0.0,lun=1 \
-drive file=/home/zhang/img/test.img,if=none,id=drive0,format=raw


Below is the syslog related to 'scsi|SCSI'

# dmesg | grep SCSI
[    0.392494] SCSI subsystem initialized
[    0.460666] Block layer SCSI generic (bsg) driver version 0.4 loaded (major 
251)
[    0.706788] sd 1:0:0:0: [sda] Attached SCSI disk
# dmesg | grep scsi
[    0.511643] scsi host0: Avago SAS based MegaRAID driver
[    0.523302] scsi 0:2:0:0: Unexpected response from lun 1 while scanning, 
scan aborted
[    0.540364] scsi host1: ata_piix
[    0.540780] scsi host2: ata_piix
[    0.702396] scsi 1:0:0:0: Direct-Access     ATA      QEMU HARDDISK    2.5+ 
PQ: 0 ANSI: 5

When 'lun=1' is changed to 'lun=0', there is no issue.

Thank you very much!

Dongli Zhang



reply via email to

[Prev in Thread] Current Thread [Next in Thread]