[Qemu-devel] [PULL v2 13/31] lsi: check if SIGP bit is already set in Wait reselect

[Paolo Bonzini]

From: Sven Schnelle <address@hidden>

If SIGP is set, the 'Wait for Reselection' command should jump
immediately to the address stored in the second DWORD of the
instruction. This fixes spurious hangs in the HP-UX 11.11
installer when the SIGP bit gets set by the kernel before the
'Wait for Reselection' command is executed by SCRIPTS.

Signed-off-by: Sven Schnelle <address@hidden>
Tested-by: Helge Deller <address@hidden>
Message-Id: <address@hidden>
Signed-off-by: Paolo Bonzini <address@hidden>
---
 hw/scsi/lsi53c895a.c | 6 ++++--
 1 file changed, 4 insertions(+), 2 deletions(-)

diff --git a/hw/scsi/lsi53c895a.c b/hw/scsi/lsi53c895a.c
index 8ba07f8..bcff859 100644
--- a/hw/scsi/lsi53c895a.c
+++ b/hw/scsi/lsi53c895a.c
@@ -1297,8 +1297,10 @@ again:
                 }
                 break;
             case 2: /* Wait Reselect */
-                if (!lsi_irq_on_rsl(s)) {
-                    lsi_wait_reselect(s);
+                if (s->istat0 & LSI_ISTAT0_SIGP) {
+                    s->dsp = s->dnad;
+                } else if (!lsi_irq_on_rsl(s)) {
+                        lsi_wait_reselect(s);
                 }
                 break;
             case 3: /* Set */
-- 
1.8.3.1